Building sliding cabinet doors

Sliding cabinet doors are very convenient in many cases. For example if the space near the cabinets is too small to have normal doors, than sliding ones will fit perfect. Also they are great if you have some cabinets that act as a display case.

sliding doors can be quite expensive, but the good part is that you can build them on your own.

Tools and materials:

  • Plywood, 3/4 inch
  • Table saw
  • Circular saw
  • Cabinet door slide mechanism
  • Sander
  • Drill
  • Screwdriver
  • Tape measure
  • Paint
  • Paint brush


First of all you will need to make some measurements to determine the size of the door. Although it may look simple, if you get the measurements wrong, you will waste a few sheets of plywood.

Making the cuts

Mark the perimeter of the door and use a circular saw to cut them in size. Make sure the draw straight lines and also use a straight surface to cut them.


Use an 80-grit sandpaper to make the entire surface of the door, including the edges, smooth. You can straighten up the edges. For a finer finish, use a 169-grit sandpaper.

Staining the doors

You should consider staining the wood doors in order to protect them against humidity, spills and heat. Apply as many coats of stain or paint as you consider necessary.


Take the sliding mechanism of the door and use screws to secure it, while making sure it’s leveled. It needs to be installed 1/2 an inch away from the lip of the top of the door.


Now it’s time to slide the door into position. To do this, first slide the upper part in the rails and then the lower part. Make sure that the door is sliding correctly in the rails. Move it a few times to make sure of this. Make the necessary adjustments.

building cabinet sliding doors, building sliding doors, cabinet doors, cabinet sliding doors, how to build cabinet doors, how to build sliding cabinet doors, how to install sliding cabinet doors, installing sliding cabinet doors, painting sliding cabinet doors, sliding door mechanism, sliding doors